The RY10 Professional Crack Fill Melter/Applicator’s patent-pending design uses up to 50% less fuel than traditional melter applicators and it’s got built in time saving innovations, too. Fully equipped with CSA/UL approved regulator and fuel lines provide precise control over fuel flow and kettle temperature. The sealed burner is equipped with a CSA/UL approved flameout sensor which detects flameouts commonly caused by wind and prevents fuel from flowing to the burner. Heavy-duty heat shields protect the fuel lines and cylinder from the radiant heat of the kettle. Push button start – no more wasting time searching for a striker, lighter or matches. Starting a melter has never been easier with the push button electric ignition. Side-by-side controls, including standard On-The-Fly agitation allow the operator to control agitation, flow and application of material as well as view and adjust temperature, all without leaving the operating position. The enclosed burner design is shielded from the elements and virtually eliminates flameouts by wind, which are common to torch-fired models. US & Canadian patents pending. High quality glycerine filled thermometer provides precise temperature readings and is resistant to pre-mature failure caused by constant vibration while in use. Two solid front casters allow the operator to maneuver over slanted surfaces with increased stability. Apply up to 4800 ft of crack filler per day. 139 lbs assembled.